Important Note: The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.
The jumper on the board no soldering default. In this case the board powered by FC
·Dimension(mm): 28 x 19 x 5
·Weight(g): 9(include all wire)
Pixhawk/APM flight control only one I2C interface, such as the need to connect more than one I2C peripheral, you can use the line board; Pixhawk - I2C points line board with five completely parallel vertical 1.25 4 a socket, convenient connection in the form of 1 drag 4 four I2C peripherals, for example, at the same time use the external compass and RGB modules. I2C line board and Pixhawk flight control the appearance of the connection (please note that this price includes only the I2C line board and cable) :
12 × 30 × 6mm
Note that if the existence of the cable portion of red and black lines received the wrong location, please ignore, because it does not affect the use, but the color sequence is incorrect, you can swap your own if necessary.
PPM Encoder x1
10Pin input cable 60mm X 1
4Pin output cable 100mm X 1
I2C breakout board × 1
Cable 60mm × 1