DFRduino GPS Shield for Arduino has now been updated to ublox LEA-6H.
u-blox KickStart provides accelerated startup at weak signals, and our featured SuperSense® Indoor GPS is capable of tracking and acquiring even extremely weak signals. This makes the LEA-6H suitable for solutions using small or covert antennas.
Power supply: 2.7 V-3.6 V
Power consumption: 117 mW @ 3.0 V (continuous)
33 mW @ 3.0 V Power Save Mode (1 Hz)
Backup power: 1.4 V - 3.6 V, 22 A
u-blox 6 position engine
Navigate down to -162 dBm and -148 dBm coldstart
Faster acquisition with AssistNow Autonomous
Configurable power management
Hybrid GPS/SBAS engine (WAAS, EGNOS, MSAS)
A-GPS: AssistNow Online and AssistNow Offline services, OMA SUPL compliant
Supports GLONASS, Galileo ready (LEA-6H)
Backward compatible (hardware and firmware); easy migration from LEA-5 or LEA-4 families
Based on GNSS chips qualified according to AEC-Q100
Manufactured in ISO/TS 16949 certified sites
LCC package for reliable and cost effective manufacturing
Operating temperature range: -40°C to 85°C
1 UART, 1 USB and 1 DDC (I2C compliant) interface
Navigation update rate up to 5 Hz (ROM version), 2 Hz (Flash)
Position: 2.5 m CEP
SBAS: 2.0 m CEP
GPS Shield x1
Passive Attena x1"