T-Bar Slide Hammer:The heavy duty T-Bar Slide Hammer allows firm pulling action while repairing large dents, deeper damage on thicker metal or creased dents on the body line.
PDR Hammer: Used for tapping down high points with the tap down.
Tap Down: Used for tapping down high points with the PDR Hammer.
Glue Scraper:Used to remove glue from the automotive panel.
Black PDR Glue Sticks:Super adhesion all temp glue
24 Unbreakable Assorted Black Crease Pull Tabs:They are designed for all kinds dent such as medium & small dents, deep dents, creases, body lines and longer dents.
1.Clean the area to be repaired with 91% isopropyl rubbing alcohol and a clean towel. It is important to remove all wax and grease from the surface to insure the glue and dent pulling tabs properly adhere to the damaged area.
2.Apply the glue pulling tab to the exact center of the dent. Avoid applying too much pressure when placing the dent pulling tab to the dented area, so you do not create too thin of a layer of glue between the car panel and the pulling tab.
3.Allow the glue to set for about 5 minutes prior to using any glue pulling tool. The glue should be hard to the touch at the time you begin repair. If your fingernail leaves an impression in glue, simply allow a couple more minutes for glue to harden. Keep the panel to be repaired out of the direct sunlight so the glue will set properly.
4.It is common for the dent pulling tab to release from the glue, leaving the glue on the panel of the vehicle. When this occurs, spray 91% rubbing alcohol on the edge of the glue and peel it away using the plastic scraper.
5.You may need to repeat steps until the desired result is achieved. It is not uncommon to repeat the process up to times.