Part number: 279973 8577274 3392519
In addition to replacing the thermal cut off and the hi-limit thermostat, make the following checks.
1.Disconnect power or unplug dryer.
2.Check for a failed or damaged heat element.
3.Check for electrical continuity across both terminals of the heat element.
4.Check for any/all causes for heat element on with no/low air flow.
A. Plugged lint screen.
B. Blocked, clogged, or kinked exhaust vent.
C. Too long exhaust, too many elbow, less than 4" diameter.
D. Inoperative flapper on exhaust hood,
E. Blower wheel not in place or not turning with motor.
F. Check 1m-2m motor switch contacts-should open when dryer is off.
G. Heat circuit timer contacts must be open when the timer is in the OFF position.
Note: (This kit can only be installed on 29" and 27" electric dryers. DO NOT install this kit on compact dryers or 24" over/under laundry products or gas dryers)
1.We provide clear pictures, measurements where possible. Please check as much as possible to make sure the item is the one that you need.
2.Please allow 0.5-1 inch difference due to manual measurement.(1inch=2.54cm)
3.Although instruction is included.Professional Installation Is Highly Recommended!