More Than A Holder!
TechElec Magnetic Mini Mount Holder can also be used as a kickstand to hold the device in place on a flat surface.
THE PERFECT VIEWING ANGLE
The high quality 360 Degree ball mount allows you to adjust to any angle, so you can always keep your phone fully in view!
HOW THE MAGNETIC PART WORKS:
TechElec car mount comes with a very slim adhesive metallic disk. Simply stick that on the back of your phone, and then place it over the magnetic mount. Voila- your device will stay firmly attached, WITHOUT any damage whatsoever!
1. Before removing the backing, test the position of the dash ball mount in a few different places on dash. For best result, test with phone attached to dash ball mount to choose location.
2. Use the alcohol pad to clean chosen area. Do not use any household cleaners. If the dash ball mount will be installed onto a hard surface such as hard plastic, metal or wood veneer, go to step 3.
3. Peel the adhesive backing from dash ball mount carefully, position the ball mount at the dash board and then press firmly into the place.
4. Wait for 24 hours before applying device to dash ball mount to allow sufficient cure time for adhesive
1. Please attention due to hot weather, when stick the pad, please use this holder after 24H.
2. The 3M adhesive stuck on the holder is disposable, which means it can only be used once. The product comes with three 3M adhesive tapes, so please find a right position before fitting it.
3. While this magnet will not harm your phone, make sure to keep it away from credit cards, pacemakers, and other magnet-sensitive devices!
1 x TechElec Phone Magnetic Holder
2 x Round Metallic Plates
1 x Alcohol pad
3 x Additional 3M VHB Mount Adhesives (only can be used once)